-Resolved issue where some VidCAD Lite users were not able to create 2-D Rack Drawings.
-Resolved issue where some VidCAD Lite users were not able to use the Jack Panel utility.
-Resolved issue where the VidCAD Main Menu would close if you hit the Escape key.
-Resolved issue with Facility Rename process where the old facility name would still display in several areas.
-Resolved issue where the the Facility Check In/Check out utility would add the facility to the wrong directory path.
-Resolved issue where users with older drawings with multiple layout tabs were getting "Internal Error" message.
-Enhanced Phantom Cable Transmutate for Bridged Cables to make source or destination selection more intelligent.
-Resolved issue with VidCAD Layer Settings window where some users would turn off the Connector or other information and the Phantom Cable Transmutate process would turn them back on. The Phantom Cable Transmutate or Cable Create Real mode commands will turn on the connection information needed but restores the layer settings back to its desired state after it is complete.
-Resolved issue where the Equipment Line Text limit was 9 characters instead of 10 if you were not using the High/Low fields.
-Resolved issue on Router Equipment where VidCAD was allowing users to create line text for I/O's greater than 10 characters.
-Resolved issue where the mouse would "lose focus" after selecting equipment from the Equipment Recall window. Some users (mostly those with dual monitors), had reported the mouse would automatically move to the other screen and would have to be moved back to the workspace for each piece of equipment recalled.
-Resolved issue where Dynamic Edit would display some equipment as "Not in Drawing" even though it was in a drawing.
-Resolved issue were some VidCAD OEM users were not able to use the Ergoman insert commands.
-Resolved issue where the InterCONNECT utility would crash the drawing if a connection through a Jack Panel or Distribution Amplifier looped back to the original piece of equipment.
-Resolved issue where some users were getting a false "could not lock file" message because there is a command running on another drawing even though there was not.